The Stripe HOG SH 24.0 from HOG Technologies is a water blasting system designed for large-scale jobs, including runway rubber removal, airfield marking removal, airfield marking rejuvenation, and surface retexturing.
The Stripe HOG SH 24.0 uses two 40,000 PSI (2,750 bar) ultra-high-pressure pumps to deliver water at a rate of 24 gallons per minute (91l per minute) through the needle-sharp water jetting nozzles. With a flow rate this high, the SH 24.0 boasts the fastest removal rates in the industry today. It can remove rubber at a rate of 60,000ft² (5,574m²) per hour on either asphalt or concrete runway surfaces.
The SH 24.0 has the unique feature of utilising up to three of HOG Technologies’ Triple Spray Bar blasting head. This head contains three 16in spray bars under a single shroud for a 48in-wide blasting path. With three of them side-by-side, you can have a blasting path upwards to 140in with no overlap.
With a blasting path that wide, runway rubber removal can be performed at a rapid and efficient rate, saving you both time and money. In addition, runways need to occasionally be retextured due to the effects that constantly changing hot and cold climates can have on the surface. Utilising three Triple Spray Bars, surface retexturing jobs are also performed in an efficient manner.
All of the Stripe HOG models feature simultaneous vacuum recovery of dirt and debris as blasting is happening. Because of this, if there is ever the need for an emergency landing at the airport, the Stripe HOG can shut down and vacate the runway in under one minute.
All of this is performed using clean, potable water with no harsh chemicals added. Unlike past methods of sandblasting, scorching, or using chemicals for removal, water blasting is clean, safe, and environmentally friendly. The needle-sharp water jets can do more than other methods can’t such as getting down into the micro and macrotexture of the surface to remove markings and other built-up sediments all while doing the least amount of damage to the surface.
All of our vehicles come with a training program called HOG Tech University. HOG Technologies is the only manufacturer of equipment that requires a license to operate. This is because HOG Technologies believes that a well-trained operator will have a much higher success rate with a job than someone who is untrained or unqualified to run or operate the equipment. The leading cause of damaged surfaces is the results of untrained people operating the vehicle.
The goal at HOG Technologies is Maximise Productivity, Minimise Costs, and Optimise Results. In order to achieve this, all of our Stripe HOG operators need to be properly trained on how to run the equipment. HOG Tech University does this through initial and constant training, by requiring operators to take refresher courses to renew their licenses, and by offering incentives for doing a job well done.
HOG Technologies remains committed to being your Total Pavement Solution.